web analytics

01.21.14

Valentine's Day Garland Craft

I wanted a little something to spruce up our temporary snowbird home for Valentine’s Day. After a bit of thought I decided to make a banner to go above the fireplace. This took about an hour to put together, but it is a good project to work on while watching tv or a movie. I love how inexpensive it was to make. I found the fabric at Walmart. It ended up being 75 cents for a quarter yard. I picked up three different prints of fabric and a quarter yard of tulle. I love how the tulle adds a different texture to the banner.

valentine's day banner

The finished project looks great and it cost less than $5 to make.

SUPPLIES NEEDED

3 different red prints fabric, 1/4 yard each (Total $2.25–fabric was $3/yard at Walmart)

1/4 yard red tulle (total $.50–$1/yard at Walmart)

2 1/2 yards of cord (total $2.00 at JoAnne’s)

Scissors

valentine's day banner

Cut fabric into four (semi) equal strips. I didn’t measure it out. I just cut the fabric in half and then cut it in half again.

valentine's day banner

Stack the four strips of fabric on top of one another and cut them into, approximately, 1 inch strips.

valentine's day banner

When you are done you should have a pile of fabric ready to be tied onto the cord.

valentine's day banner

To start, make a loop at one end of the cord.

valentine's day banner

Tie a piece of fabric around the loop bottom to hold it in place. I found that two piece of fabric tied tightly on the loop bottom work s best.

valentine's day banner

Loosely tie the remaining strips of the fabric onto the cord. A simple knot works best. Don’t tie too tightly otherwise there will be kinks in the cord and it won’t hang nicely. Continue tying until the cord is almost covered. Create another loop at the end like you did at the start. This creates an easy way to hang the banner.

valentine's day banner

One Comment

  1. Posted January 21, 2014 at 12:13 pm | Permalink

    This is so cute!!

Post a Comment

Your email is never published nor shared. Required fields are marked *

*
*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>